DISTORTIONAL FAILURE AND DSM DESIGN OF COLD-FORMED STEEL S SHAPED BEAMS UNDER UNIFORM BENDING

Authors

  • CAROLINA BARICHELLO COPPE/UFRJ - INSTITUTO ALBERTO LUIZ COIMBRA DE PÓS-GRADUAÇÃO E PESQUISA DE ENGENHARIA
  • ALEXANDRE LANDESMANN ALEXANDRE LANDESMANN ASSOCIATE PROFESSOR, D.SC. FEDERAL UNIVERSITY OF RIO DE JANEIRO (UFRJ) CIVIL ENGINEERING PROGRAM ILHA DO FUNDÃO, ZIP: 21941-972 POB 68.506 RIO DE JANEIRO/RJ - BRAZIL TEL: (+55 21) 3938.8493 | FAX: (+55 21) 3938.8484
  • DINAR CAMOTIM CIVIL ENGINEERING DEPARTMENT, ICIST, INSTITUTO SUPERIOR TÉCNICO, UNIVERSITY OF LISBON, PORTUGAL

Keywords:

DISTORTIONAL FAILURE, COLD-FORMED STEEL BEAMS, SHELL FINITE ELEMENT

Abstract

THIS WORK REPORTS A NUMERICAL INVESTIGATION ON THE DISTORTIONAL BUCKLING/POST-BUCKLING BEHAVIORS, ULTIMATE STRENGTH AND DIRECT STRENGTH METHOD (DSM) DESIGN OF COLD-FORMED STEEL S-BEAMS, COMMONLY USED IN INDUSTRIAL RACK SYSTEMS. THE ANALYZED BEAMS ARE SINGLE-SPAN, UNDER UNIFORM BENDING, EXHIBITING TWO DIFFERENT END SUPPORT CONDITIONS AND 5 CROSS-SECTIONS DIMENSIONS. THE POST-BUCKLING EQUILIBRIUM PATHS AND ULTIMATE MOMENTS ARE OBTAINED FROM SHELL FINITE ELEMENT NON-LINEAR ANALYSIS THROUGH THE SOFTWARE ANSYS. THE REPORTED RESULTS EVIDENCED THAT CURRENT CODIFIED DSM DISTORTIONAL CURVE IS UNABLE TO PROVIDE SAFELY STRENGTH PREDICTIONS FOR THE SELECTED BEAMS.

Author Biography

CAROLINA BARICHELLO, COPPE/UFRJ - INSTITUTO ALBERTO LUIZ COIMBRA DE PÓS-GRADUAÇÃO E PESQUISA DE ENGENHARIA

PEC - PROGRAMA DE ENGENHARIA CIVIL

Downloads

Published

2017-08-26

Issue

Section

Articles